How to use a ribbon slitting machine

The use of the ribbon slitting machine may vary depending on the specific model and brand, but the general operation steps are roughly the same. The following is a general guide to the use of ribbon slitting machine:

First, preparation before start-up

1. Check the power supply: Make sure the power cord of the slitting machine is properly connected, and the voltage and current are stable.

2. Check the hydraulic oil level: Turn on the power switch of the hydraulic system, and check whether the oil level of the main hydraulic drive system and the pressure gauge are correct and stable.

3. Check the air pressure: open the pneumatic shut-off valve and check whether the air pressure is correct and stable (generally not less than 6.0bar).

4. Set slitting parameters: Set the slitting menu according to the type, thickness, length and other requirements of the ribbon, and extract the corresponding ribbon files.

Second, feeding and film threading

1. Feeding: Place the ribbon parent roll on the unwinding rack of the slitter, and clamp the steel core with the control button.

2. Threading: Using the threading device and function key of the slitting machine, tie one end of the ribbon to the ring eye of the threading chain, and start the threading button, so that the ribbon is evenly distributed on each roller along the slitting process.

Third, boot operation

1. Check the preparation: Confirm that all settings are correct, the paper core is on the inner and outer winding arms, and the pressure roller is in the state of running preparation.

2. Notify personnel: Notify all personnel to leave the machine to ensure personal safety.

3. Start the machine: Put the ANTI-STAIC BARS on the main console to AUTO, READY TO RUN to start, and start the MACHINE RUN.

Fourth, slitting control

1. Monitoring and observation: In the process of slitting operation, carefully monitor and observe the slitting effect of operation.

2. Adjustment control: according to the need, the slitting speed, unwinding tension, contact pressure and arc roller, edge material traction roller, guide edge and so on are appropriately adjusted and controlled.

Fifth, receiving and parking

1. Receiving: When the inner and outer end of the winding machine stops running, use the film unloading button to put the ribbon on the prepared film unloading trolley, cut the ribbon and paste the ribbon roll with sealing glue.

2. Parking:

• When the ribbon roll runs to a set length, the machine will automatically stop.

• If you need to stop the machine during the operation of the machine, you can press the MACHINE STOP button.

• In case of emergency, press the EMERGENCY STOP button to make an emergency stop.

Sixth, precautions

1. Safe operation: When operating the ribbon slitting machine, the safety operation procedures should be strictly adhered to to avoid personal injury or equipment damage.

2. Maintenance: Regularly maintain the ribbon slitting machine, including cleaning, lubrication, inspection, etc., to ensure the normal operation of the equipment and prolong the service life.

3. Troubleshooting: In the process of operation, in case of equipment failure or abnormal situation, the machine should be stopped immediately and the professionals should be notified for maintenance.

Through the above steps, you can basically master the use of ribbon slitting machine. However, please note that the specific operation steps may vary depending on the model and brand of the equipment, so you should refer to the instruction manual of the equipment or consult a professional in actual operation.