News

This article will explain in detail how to effectively solve the problem of uneven thickness caused by slitting through the knife gap fine-tuning method.

How to effectively control black spot impurities through a clean slitting process has become an urgent technical issue in the industry.

The low efficiency of rewinding is a problem of operation speed on the surface, but in essence it is the limitation of equipment architecture.

If your slitting machine takes more than 3 minutes to change the roll at a time, then this article is for you.

I hope the tips in this article can help you effectively reduce the film breakage rate in practice, improve the slitting yield rate and production efficiency.

The noise of the hot stamping foil slitting machine is not an inevitable "normal phenomenon", it is often a direct reflection of the deterioration of the accuracy of the equipment.

Once the back coating is scratched, scratched, embossed and other damages in the slitting process, it will cause printing stuttering, broken needles, and scrapping of the entire ribbon.

This article will systematically analyze the causes of knife shaft runout and provide a complete solution from detection to repair.

The following is a systematic analysis of troubleshooting ideas and solutions from multiple perspectives.

So, what should I do when I encounter wrinkles? The following provides a set of quick troubleshooting steps in the order from easy to difficult and from outside to inside.