What are the common failures encountered in the process of tape slitting and rewinding

For the paper processing industry, the tape slitter is a very important equipment, almost every day to use this equipment, if the failure will hinder the production process, reduce production efficiency. Therefore, daily maintenance is a must, and the following points are summarized for reference, I hope to help you

1. The tape slitting machine is unevenly winded.

Most of this situation is due to the fact that the paper core is not suitable, as long as the paper core that meets the required inner diameter is replaced, and the winding pressure roller is used in the winding process, it can also avoid uneven winding of the slitter.

2. The meter counting is not accurate.

This problem can make the meter wheel double wheel contact the feeding rubber roller at the same time, and make a mark on the meter wheel hand crank 5 times for the count of 1 meter, otherwise replace the meter meter.

3. Slitting and winding materials.

This is mainly due to the wrong winding tension, adjust the suitable winding tension of the paper slitting machine, use the pressure roller for winding and wrap the slitting material over the pressure roller before entering the winding core.

The above is how to eliminate the common faults encountered in the process of tape slitting and rewinding, I hope it can help you.