
The slitting machine has waves at the margin during slitting, forming a high edge and low center, and the winding and rewinding will show problems such as cracks and broken belts... This condition is due to uneven marginal cuts and stacking, which is also related to the winding manipulation.
There are many reasons for this problem, which needs to be specifically analyzed, the most important of which is related to the correction before the pole piece enters the slitting part, and it is also possible that the edge of the pole piece is not neat, and the deviation correction movement is fierce during slitting, or the running speed of the pole piece of the slitting machine does not match the running speed of the slitting prop, or the knife edge of the machine may not mesh well, or the knife edge may be blunt.
If there is a wavy edge but there is no burr phenomenon that can be swept away is the phenomenon of blunt knife, the most likely is that the upper and lower knives do not match, the winding is slightly biased, and the tension control problem.
The problem of lotus margins in the material after slitting: the first point is that the hardness of the blade of the slitting machine is not good, and it will become soft after a long time of operation, which will then lead to the phenomenon of ruffles; The second point is that the slitting machine tension is not stable. In this case, it is necessary to replace the blade or adjust the tension.
The slitter blade is one of the important components of the slitting machine equipment. If the selection is improper, the service life of the slitting blade is shortened, the slitting target requirements cannot be met, and the slitting material will have burrs and a lot of slitting chips.

no need to buy a dedicated machine or gamble on a mismatched machine just because of a rushed resin-based washing order.
16. November, 2026
This article will start from symptom classification and provide a solution approach that progresses from simple to complex and can be quickly implemented.
16. November, 2026
As a result, a well-calibrated high-precision ribbon slitting machine can stabilize width tolerances within ±0.05mm, and reduce the defect rate from 2% to 3% of ordinary equipment to below 0.3%.
16. November, 2026
accuracy indicators will move from macro to micro, control logic will shift from experience to algorithms, and equipment roles will move from isolated islands to nodes.
10. November, 2026
The following three application cases reveal the efficiency revolution currently underway in this area.
09. November, 2026