
Slitting machines are commonly used in papermaking machinery, wire and cable mica tape and printing and packaging machinery. When the slitter cuts the paper, it will show that the paper is not blocked. Let's not be nervous. We take a closer look at the problem and find the corresponding solution to solve the problem. Then we know that the slitting machine is not cutting the paper properly. How do we solve these problems?
1. The lower roller of the slitting machine is connected with two paper rollers, and the paper is not cut is a small problem that often occurs. If this problem occurs, first check that the cutter blades are intact. If it is in good condition, after installing the paper cutter, check that the paper cutter is connected to the bed knife.
2. When the slitting machine is not in place during the rise of the paper cutter, first check whether the external limit is normal, and then check whether the paper cutter gearbox does not rise enough due to the low oil level. Check that the three rows of chains of the cutter are not too long.
3. When the manual rolling and beating of the paper cutter of the slitting machine is large, remove the paper cutter head and replace the upper round knife shaft.
4. When lifting the paper cutter, when fixing the knife holder on the drum, first check whether the cylinders on both sides of the paper cutter are working normally during the lifting process. If one cylinder is not moving, the turret will be attached to the roller surface. At this point, the cylinder needs to be replaced.
The abnormal operation of the slitter is mainly as mentioned above. The abnormal operation of the slitter is mainly as mentioned above. The abnormal operation of the slitting machine is mainly reflected in the above places. We all need to address the above issues.

no need to buy a dedicated machine or gamble on a mismatched machine just because of a rushed resin-based washing order.
16. November, 2026
This article will start from symptom classification and provide a solution approach that progresses from simple to complex and can be quickly implemented.
16. November, 2026
As a result, a well-calibrated high-precision ribbon slitting machine can stabilize width tolerances within ±0.05mm, and reduce the defect rate from 2% to 3% of ordinary equipment to below 0.3%.
16. November, 2026
accuracy indicators will move from macro to micro, control logic will shift from experience to algorithms, and equipment roles will move from isolated islands to nodes.
10. November, 2026
The following three application cases reveal the efficiency revolution currently underway in this area.
09. November, 2026