
In the process of slitting machine maintenance, it is very important to do a good job of inspection, so what do you need to pay attention to when carrying out the maintenance and inspection of the slitting machine?
1. When starting the slitting machine, use the small tool driver to rotate the shaft, let the press frame reciprocate many times, and check that there are 2 jams.
2. In the engineering project where it is applied, if the cardboard part is not placed or the finished product cannot be removed immediately, in order to prevent waste, it should be immediately "opened and pulled down, and then the cardboard is corrected, and then the "empty calibration" is then "opened".
3. In the area of each oil inlet of the slitting machine, fill and moisten with grease, observe whether the fuel pipe and motor shaft are unobstructed, and the oil supply is not more than five times.
4. Check the safety device of the slitting machine, and whether the screws are loose.
5. The slitting machine should be repaired and maintained in an all-round way for many times to prevent the application of it at that time, when there is an abnormality, the paper guide equipment can not immediately carry out order information, resulting in heavy losses.
Therefore, when the slitting machine is maintained and inspected, these details should be done to ensure its good performance

no need to buy a dedicated machine or gamble on a mismatched machine just because of a rushed resin-based washing order.
16. November, 2026
This article will start from symptom classification and provide a solution approach that progresses from simple to complex and can be quickly implemented.
16. November, 2026
As a result, a well-calibrated high-precision ribbon slitting machine can stabilize width tolerances within ±0.05mm, and reduce the defect rate from 2% to 3% of ordinary equipment to below 0.3%.
16. November, 2026
accuracy indicators will move from macro to micro, control logic will shift from experience to algorithms, and equipment roles will move from isolated islands to nodes.
10. November, 2026
The following three application cases reveal the efficiency revolution currently underway in this area.
09. November, 2026