
Today, we are going to talk about the method and precautions for operating the slitting and rewinding machine, I hope it can be helpful to you.
1. Ensure that the voltage, current and hydraulic equivalent values are correct and stable before starting.
2. Before the equipment is ready to run, all personnel must be notified to leave the equipment to ensure personal safety before starting and running.
3. When running, do not touch the running film roll or roller core with your hands, so as not to involve your hands and cause personal injury.
4. During the operation, do not scratch or cut each roller core with a knife or hard object.
The first packaging: before the equipment is put into work, check whether each working position is properly adjusted, and the parts that need to be lubricated should be filled with lubricating grease in advance. Check that the knives are sharp.
After everything is normal, you can run the empty car first, check whether there is any abnormality, and enter the order to be processed into the computer for inspection in advance; After the equipment is put into work, the best working condition of the equipment should be adjusted in time according to the production situation to ensure that the indentation of the slitting machine is moderate, the slitting is burr-free, and the trimming position on both sides is appropriate. To ensure that the cross-cutting machine feeds and discharges the paper smoothly and the cutting length is accurate, it is also necessary to monitor the operation of the vertical and horizontal cutting machine that is connected to production management, so as to prevent the phenomenon of paper blocking and the generation of defective products;
After the work is completed, clean up the dust and paper scraps on the equipment in time, check the grinding wheel with the sharpener, drain the water in the oil and water reservoir, and check whether there is any abnormality in the operating parts. Then, cut off the power supply according to the operation requirements of the manual, and maintain the computer operating system.

no need to buy a dedicated machine or gamble on a mismatched machine just because of a rushed resin-based washing order.
16. November, 2026
This article will start from symptom classification and provide a solution approach that progresses from simple to complex and can be quickly implemented.
16. November, 2026
As a result, a well-calibrated high-precision ribbon slitting machine can stabilize width tolerances within ±0.05mm, and reduce the defect rate from 2% to 3% of ordinary equipment to below 0.3%.
16. November, 2026
accuracy indicators will move from macro to micro, control logic will shift from experience to algorithms, and equipment roles will move from isolated islands to nodes.
10. November, 2026
The following three application cases reveal the efficiency revolution currently underway in this area.
09. November, 2026